These how to videos and articles of information are dedicated to my woodworking instructor who trained me during my apprenticeship. This body of work is also in honor of the journeyman who were generous in sharing their woodworking knowledge and skills with me throughout my long career. All of you have helped me to make a wonderful living in a great craft. My hat is off to all of you.
That just reminded me of a FWW piece many years ago that had me rolling on the floor. Craftsman had built a large piece being delivered to an apartment on the top floor. Couldn't get it on the elevator so they got controll of the elevator and ran the top of it to be even with the floor, loaded the piece on the top of the car and rode with it inside the shaft while balancing it and keeping it from hitting the shaft walls. At some point in the trip up they lost control of the elevator and it started making trips up and down to other floors. I'll see if I can find it.
I taught (teach) several aspects of "green woodworking" and related subjects, so I love your question. The buying and using of old tools is great...no matter the source. However, I have seen much frustration ensue over getting them adjusted, and "work ready." As often a beginner with limited budgets, also have limited traditional skill sets as well in understanding these tools and sharpening them. You must be patient with yourself, as tuning these old tools up will be very time consuming. Sharpening (and the proper tools of sharpening) should be your first acquisition. So many folks buy chickens before building a proper "chicken coop." Traditional tools are the same way, as there is no reason to own them, if you can't keep them properly honed.
Before you bid in an online auction, check the site’s rules of operation. At some sites, a winning bid is a binding contract, which can be a problem if you can’t inspect the tool before you purchase it. Don’t forget shipping costs. In some cases they can exceed the cost of the tool. Also, make sure the tool you’re buying will run on the power you have in your shop. Many former industrial tools run on 240v single-phase power. If your shop doesn’t have 240v service, you’ll need to factor in the cost of upgrading before deciding to buy. You don’t want to saddle yourself with a tool you can’t use, no matter how good the price.
To get the most out of your router, you are going to want a router table. You may find yourself asking if you really need one - if you do, check this post out. It's one of those purchases that you won't truly understand how valuable it is until you have one. Given the budget of $2,500, I'd suggest looking at the Bosch RA1171 ($150). If you want to see our favorite tables along with write-ups, check them out here.
An old piece of wood and a few hooks will help you to create a beautiful hanger for your favorite coffee cups. Just add the hangers, stain the wood and then hang it on the wall. This is a project that takes little time and will cost very little if you already have the wood on hand. You just have to purchase the hangers which are relatively inexpensive.
First, let's dump that hand powered saw/miter box. It gets the job done, but it takes forever. We're still on a lean budget, but shelling out ~$110 for a 10 inch electric miter saw makes a lot of sense. This won't be your forever saw, but it should do fine for most projects. It can handle up to a 4x6 stock which will cover 99% of what a beginning wood worker will throw at it.
"Woodworker's Supply, Inc. failed to properly investigate these complaints and failed to protect Ms. [Teresa] Logsdon from illegal sexual harassment, and gender discrimination in the workplace," according to the complaint filed by her attorney Wendy Owens of Casper in July. "Ultimately, Ms. Logsdon had no choice but to give notice of resignation to protect herself."