Since I long ago lost the woodcarving tools I used to own as a youth, I figured I would focus on something larger. With my current ideas of doing a commercial greenhouse venture, I have considered making my first project one of a pergola for training plants up as a living shade-tent area. I have also considered trying to do an earth-sheltered greenhouse assuming I can figure out a loophole in city ordinances and/or coax the officials to sign off on it. I would love to do some hand-carved bowls and eventually make my own workbench and maybe even craft other things like a shaving horse. A foot-powered lathe is another one that I still find fascinating from the Foxfire books.
All you need to get an edge on your hand tools and pocket knives is a 100/300 grit combo stone from your local hardware, even horrible fright. This shouldn't cost more than $10. Then go to the natural slate section of the home center or flooring store & find 3-4" natural slate tile that you can barely see the grains in. This should cost another $1 or so. This tile is roughly 800 grit. If you can't find natural tile in your area, you should be able to find an 'Arkansas' stone for <$5. If you can scare up some Chrome Oxide and a piece of leather (piece of cardboard or block of MDF also work) all the better. These three things will cost you $15 and get your edged tools sharp enough to take hair off your arm and chips of your lumber.
I Like to Make Stuff is the perfect channel for beginners who want comprehensive teaching on woodworking. It has a show called Maker 101 that goes into the basic skills you need to start making stuff. I Like to Make Stuff is not intimidating to the beginner because it isnâ€™t afraid of showing woodworkers making mistakes on their project rather than always doing everything perfectly.
The next important hand tool for the woodworker is an accurate tape measure. Get a retractable one that is at least 25 feet long. Any longer than that, and you start having problems getting it to roll back up. Since measurements on large scale projects can be very susceptible to even the most minute measurement variations, you’ll want to make sure the “hook” or tab at the end of the is firmly attached, with no give. When they get loose, you’ll have as much as 1/8” variation in your measurements. This can add up to some severe accuracy problems in the long run.